mypros+
Model reference

GE JBP66BY3WH

Range

5 documents13 error codes9 service modes

Available documentation

Service Manual

  • Technical Service Guide 1999 Spectra Series - Free-standing Electric Ranges W/ Truetemp39 pg
    Covers this model
  • GE Consumer Service Training Technical Service Guide 30" Free-Standing Radiant / Convection Range40 pg
    Covers this model
  • Technical Service Guide 1999 Spectra™ Series - Free-standing Electric Ranges W/ Truetemp™39 pg
    Covers this model
  • Technical Service Guide 1999 Spectra™ Series - Free-standing Electric Ranges W/ True Temp™39 pg
    Covers this model

Training

  • Technical Service Guide 1999 Spectra™ Series - Free-standing Electric Ranges W/ Truetemp™39 pg
    Covers this model
MyPros+ Max

Diagnose your GE JBP66BY3WH.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (13)

CodeMeaning
F0Stuck key pad or transistor failure; may mean relay is turned on.F1Stuck key pad or transistor failure; may mean relay is turned on.F2Oven over-temperature detectedF3Open oven temperature sensor circuit (over 2700 ohms).F4Shorted oven temperature sensor circuit (under 950 ohms); could be…F5Loss of relay drive circuit.F7Stuck key pad or transistor failure; may mean relay is turned on.F8Sensor circuit related failure.F9Door lock switch failure.FCProblem with door lock circuit such as pinched wires between control and door…FdShorted meat probe detected.FFDoor motor safety switch transistor failure.PFPower failure indication

Service modes (9)

  • Bake Temperature Calibration (QuickSet 2 & 3)["Press and hold both the INCREASE and DECREASE HOUR pads for about 4 seconds.","Display will…
  • Bake Temperature Calibration (QuickSet 4 & 5)["Press BAKE pad.","Select any temperature above 500°F by pressing the INCREASE pad.","Immediately…
  • Child Lockout (QuickSet 5)["Press and hold INCREASE/DECREASE pads along with STOP TIME pad for approximately 2 seconds.","The…
  • End of Cycle Tone Elimination (QuickSet 5)["Push and hold the CLEAR/OFF pad for 10 seconds."]
  • ERC On-Board Diagnostic Test Mode1
  • ERC On-Board Diagnostic Tests1
  • Fault Code Memory Test1
  • Increase/Decrease Pad Speed Adjustment (QuickSet 5)["Press and hold Increase/Decrease and Timer pads for 2 to 3 seconds.","A number between 1 and 5…
  • Special Features Mode (ERC V)Press the BAKE and BROIL HI/LO pads at the same time for 2-3 seconds until the display shows 'SF'.

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass