Model reference

GE GTUP240

Washer

3 documents16 error codes1 service mode

Available documentation

Service Manual

GEWasherLaundryCenterGTUP240270ServiceManual31920869 pg
Covers this model

Service Flash

Laundry Centers Lid Issues3 pg
Covers this model

Tech Tip

GE Washer Dryer GTUP270 GTUP240 Laundry Centers Lid Issues TAG TIP2 pg
Covers this model

MyPros+ Max

Diagnose your GE GTUP240.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Washer

Blocked Motor on my GE GTUP240

M+

Control does not receive pulses from

From Service Manual 564012, p.24:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part WH44X10288

Door lock assembly

Error codes (16)

CodeMeaning

Blocked MotorControl does not receive pulses from the motor Hall sensor, indicating the…Fill Time OutFill timeout occurred; non-critical error displayed to consumer.Filling TimeoutControl does not receive a change of pressure from the pressure switch within 3…Lid Lock BrokenCritical failure Lid Lock FailureCritical failure Lid Lock Not Open/CloseLid cannot be locked or unlocked; control attempts 5 times, then waits 4.25…Lid SwitchControl runs 3 continuous agitation/spin cycles without receiving the lid…Lid Switch FailureCritical failure Loose BeltControl detects excessive motor speed from the Hall sensor, indicating a loose…No SpeedNo motor speed sensor feedback detected; after 3 seconds without feedback in…OverflowWater level detected higher than the expected maximum fill; water valves are…Pump TimeoutDrain pump timeout reached after 4.25 minutes of pumping without reaching…Redundancy FeedbackMain control detects that the motor controller is not activating the lid lock…ThermistorControl cannot detect the ATC thermistor; ATC is disabled and defaults to…Triac in ShortThe triacs that control the motor windings have failed.Wash TransistorWasher tries to agitate with less than the minimum allowed water level…

Service modes (1)

Washer Service Mode["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass