mypros+
Model reference

Jenn-Air JED4536KB00

Cooktop

5 documents20 error codes3 service modes

Available documentation

Service Manual

  • TECHNICAL MANUAL JennAir® 30" and 36" Downdraft Cooktop48 pg
    Covers this model
  • Technical Manual - Touch Activated Electric Cooktop60 pg
    Covers this model
  • EnerGuide1 pg
    Covers this model

Tech Sheet

  • Tech Sheet48 pg
    Covers this model

Installation Guide

  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air JED4536KB00.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (20)

CodeMeaning
E2Overheating of the induction coil (display flashing).E5Error on filter board due to incorrect wiring or error on power board.E6Error on power unit due to incorrect wiring or error on power board.E9Coil temperature sensor defective.Er 20Flash failure; microcontroller (μC) is faulty.Er 22Permanent use of keypads; control unit cuts off after 10 seconds due to water…Er 31Configuration data incorrect; configuration of induction necessary.Er 36NTC value is not within its specification (value < 200 mV or > 4.9 V); control…Er 47Communication error between touch control (TC) and induction module; none or…F0E0No error codes present in the system; controls are functioning normally.F1E0User Interface replacement needed or model mismatch error (model set error).F1E1Appliance Manager or Expansion Board failure due to welded relays, relay shift…F2E1Stuck or shorted keypad detected (key held for 30 seconds or multiple keypads…F6E0User Interface lost communication contact with Appliance Managers (WIDE bus…F6E4User Interface and Appliance Manager state status mismatch.F6E6Appliance Manager 1 (Copernicus) lost communication contact (WIN bus…F6E9Appliance Manager 2 (Expansion Board) lost communication contact (WIN bus…F6EAUser Interface over temperatureF9E0Mis-wire of the productU400Secondary voltage of the power unit too high (primary > 300 V); control unit…

Service modes (3)

  • Diagnostic Test Mode1
  • Model Setting (after replacing Copernicus AM board)Within 60 seconds of connecting power to the product, touch the keypad sequence ON/OFF, ON/OFF, +…
  • Service ModeWithin 60 seconds of connecting power to the product, touch the key sequence ON/OFF, ON/OFF, + for…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air cooktop models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass