Model reference

Jenn-Air JID4436ES0

Cooktop

7 documents12 error codes1 service mode

Available documentation

Service Manual

Service Manual - W11024161 - 36 Induction Cooktop with Downdraft Ventalition52 pg
Covers this model
TECHNICAL MANUAL JennAir® 30" and 36" Downdraft Cooktop48 pg
Covers this model

Tech Sheet

Tech Sheet16 pg
Covers this model

Tech Tip

Instruction Sheet4 pg
Covers this model
Instruction Sheet2 pg
Covers this model

Installation Guide

Instruction Sheet16 pg
Covers this model
Installation Instructions40 pg
Covers this model

MyPros+ Max

Diagnose your Jenn-Air JID4436ES0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Jenn-Air Cooktop

E/X on my Jenn-Air JID4436ES0

M+

Cooking-element-specific error; the

From Tech Sheet W10608819, p.31:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (12)

CodeMeaning

E/XCooking-element-specific error; the display of the affected element blinks with…E2Overheating of the induction coil (display flashing).E5Error on filter board due to incorrect wiring or error on power board.E6Error on power unit due to incorrect wiring or error on power board.E9Coil temperature sensor defective.Er 20Flash failure; microcontroller (μC) is faulty.Er 22Permanent use of keypads; control unit cuts off after 10 seconds due to water…Er 31Configuration data incorrect; configuration of induction necessary.Er 36NTC value is not within its specification (value < 200 mV or > 4.9 V); control…Er 47Communication error between touch control (TC) and induction module; none or…Er XXGeneral touch control error displayed on the user interface during service…U400Secondary voltage of the power unit too high (primary > 300 V); control unit…

Service modes (1)

Diagnostic Test Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air cooktop models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass