Model reference
Kenmore 40249032010
Washer
1 document18 error codes11 service modes
Available documentation
Tech Sheet
- WASHING MACHINE Technical Information19 pg
MyPros+ Max
Diagnose your Kenmore 40249032010.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (18)
CodeMeaning
1EWater Level Sensor Trouble2EVoltage for motor control bus is over or under specified limit.3EMICOM is attempting to drive the motor but is not getting any response signals…AECommunication error between SUB PBA and MAIN PBA.dcUnbalance or cabinet bump is detected during final spin, which prevents the…dsDoor is detected as open while it is trying to lock the door.E2Stuck KeyFLDoor fails to lock after 7 attempts.HrHeater Relay Failure (No Heater Relay Check Signal).LEA water level lower than the Reset water level is detected for 5 seconds during…LODoor fails to Unlock after 7 attempts.ndThe water level fails to drop below the Reset Water Level within 15 minutes.nFWhen the filling continues for more than 40 minutes or there is no change of…nF1The hot/cold water hose connection is not correct.OEA fault is detected in the water level sensorStSystem Error.SUdSuds is detected during the washing sessiontEAbnormal high/low temperature or resistanceService modes (11)
- Board Input Test Mode1
- Continuous Run Mode1
- Cycle Count Check Mode1
- Demo Mode1
- Diagnostic Code Check Mode1
- EEPROM Clear Mode1
- Fast Time Down Test Mode1
- Quick Spin Test Mode1
- Quick Test Mode1
- Service Mode1
- Software Version Check Mode1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Kenmore washer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax