Model reference

KitchenAid W11499711

Dishwasher

1 document26 error codes3 service modes

Available documentation

Service Manual

TECHNICAL MANUAL KitchenAid® and Maytag® 24" Microfiltration Dishwasher82 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid W11499711.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Dishwasher

F10E1 on my KitchenAid W11499711

M+

Dispenser electrical problem — loose

From Tech Sheet W14849208, p.20:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (26)

CodeMeaning

F10E1Dispenser electrical problem F10E2Vent electrical problem F10E3Drying fan electrical problem F10E4Diverter cannot find positions F10E5Diverter leak (Motor)F1E1Relay or triac failure on main control board (ACU).F1E2Failure of motor control (MCU) on control board.F2E1Control detected stuck keys in user interface (key switches only, not…F3E1Open or shorted connection or component in temperature sensing circuit, or…F3E2OWI calibration failure; OWI lens obstructed by hard water buildup or food soil.F4E2Open connection in heater circuit, heater component open, or heater drive…F4E3Heater relay on control shorted or heater component shorted to ground.F5E1Door was not latched within 4 seconds of pressing Start/Resume, or loose…F5E2Control suspects door switch is stuck closed; control looks for door switch to…F6E1User interface has power but cannot communicate with main control board (loose…F7E1Wash motor failure due to loose connection in motor circuit and/or faulty wash…F7E4RIF filter plugged causing clogged filter assembly.F8E1No water to dishwasher / tap closed, or water leaking, or fill valve/water line…F8E2Fill valve electrical problem F8E3Very low water / suds / air in pump F8E4Overfill switch open F8E5Fill valve stuck open F8E6Flow meter disconnected, damaged, or obstructed preventing flow meter wheel…F9E1Not draining F9E2Drain motor electrical problem F9E4Tub light circuit problem

Service modes (3)

Error Code History DisplayAfter entering Service Diagnostics Mode (all LEDs on), press Key #3 to display the most recently…
Service Diagnostics Mode1
User Interface TestAfter entering Service Diagnostics Mode (all LEDs on), press Key #1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass