Model reference

Maytag YMER8775BS0

Range

6 documents17 error codes5 service modes

Available documentation

Tech Sheet

Fiche technique - Tech Sheet W10522407 Rev B8 pg
Covers this model
Tech Sheet - W10522406 - Rev A8 pg
Covers this model

Tech Tip

Oven Cleaning Quick Reference Guide2 pg
Covers this model

Installation Guide

Installation Instructions16 pg
Covers this model
Instruction Sheet2 pg
Covers this model

Quick Reference

Quick Reference Manual2 pg
Covers this model

MyPros+ Max

Diagnose your Maytag YMER8775BS0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Range

F1 on my Maytag YMER8775BS0

M+

Internal circuit board failure / A/D

From Tech Sheet W17374171, p.23:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (17)

CodeMeaning

F1Internal circuit board failure / A/D error(s) (displayed as F1E0, F1E1, F1E2 on…F1E0Internal board failure.F1E1Internal board failure / A/D Error.F1E2Internal board failure / A/D Error.F2Stuck/shorted key on the control panel (displayed as F2E0 on LCC 180/190…F2E0Shorted key.F3Oven temperature sensor open circuit (displayed as F3E0 on LCC 180/190; also…F3E0Oven sensor opened.F3E1Oven sensor shorted.F3E2Oven excessive temperature during BAKE/BROIL mode.F3E3Oven excessive temperature during CLEAN mode.F5Door and latch switch mismatch during clean mode (displayed as F5E0, F5E2 on…F5E0Door and door position switches do not agree (Clean mode).F5E1Door latch not operating (Clean mode).F5E2Door and door position switches do not agree (Clean mode).F9Miswired house or miswired range (LCC 90/95).F9E0Miswired house or miswired range.

Service modes (5)

diagnosticPress CANCEL > CANCEL > START within 5 seconds.
diagnostic_test_modeAfter entering diagnostic mode (CANCEL>CANCEL>START), the initial display shows 'tSt' (LCC 90/95)…
Diagnostics ModePress CANCEL > CANCEL > START within a 5-second period.
Diagnostics Test Mode (Relay Checks)While in Diagnostics Mode
Temperature AdjustmentStep 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass