mypros+
Model reference

Maytag MAV5920EW

Washer

11 documents14 error codes5 service modes

Available documentation

Tech Sheet

  • Domestic Washer—Technical Information9 pg
    Covers this model

Service Manual

  • Service Manual - Top Load Washer99 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model
  • Top Load Washer Service Manual99 pg
    Covers this model

Bulletin

  • Technical Bulletin - TDL-0100-B-French Getting into and out-of Advertising mode1 pg
    Covers this model
  • Technical Bulletin - Washer will not spin1 pg
    Covers this model
  • Technical Bulletin - Melted Motor Pulley1 pg
    Covers this model
  • Bulletin technique - TDL-0143-B-French Melted Motor Pulley1 pg
    Covers this model
  • Technical Bulletin - New Hub and Seal8 pg
    Covers this model

Service Flash

  • Technical Bulletin - Install 'tub to pump' hose correctly when servicing1 pg
    Covers this model
  • Technical Bulletin - ITDL-0031-B New water pump design1 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MAV5920EW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
0No code (no fault present).1Power failure detected.15Thermistor out of range.16Thermistor possible open.17Thermistor possible short.18Motor thermal protector opened more than 5 times during a cycle.19Motor thermal protector opened.21Fill time exceeded 18 minutes.22Fill time less than 2 seconds.24Incorrect rotary switch position seen.25Rotary Switch 1 left of encoder failed at startup.26Rotary Switch 2 left of encoder failed at startup.28Rotary Switch 3 left of encoder failed at startup.31Model ID Unknown, Default model of 31 used.

Service modes (5)

  • Console Switch Test["Enter Service Mode.","Set Cycle Selection Knob to 'Delicate' and press knob
  • Display/Clear Service Codes["Enter Service Mode.","Set Cycle Selection Knob to 'Rinse & Spin'.","Press knob
  • Service Cycle["Enter Service Mode.","Set Cycle Selection Knob to 'Regular' and press knob.","'Fill' and 'Wash'…
  • Service Mode["Rotate the Cycle Selector Knob to the 'Power Off' position and press knob (all LEDs will be…
  • Service Mode (Electronic Controls)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass