mypros+
Model reference

Maytag MHW3000BG1

Washer

10 documents26 error codes5 service modes

Available documentation

Service Manual

  • Use & Care Guide - Front-Loading Automatic Washer48 pg
    Covers this model

Tech Sheet

  • MHW3000BG1 Tech Sheet W10441082 Rev B44 pg
    Covers this model
  • For Service Technician's Use Only48 pg
    Covers this model
  • Whirlpool FL Washer WFW72HEDW Tech Sheet48 pg
    Covers this model

Service Flash

  • TECHNICAL SERVICE POINTER - Front-Load, Direct Drive Washers (ALPHA) Potential Internal Hose Leak3 pg
    Covers this model
  • Technical Service Pointer - Drain Pump Assembly Relocation6 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - F1E1 Error Code with Stacked Long-Vent Dryer6 pg
    Covers this model

Training

  • Training Pointer W10642118 Changes in Hardware and Diagnostics21 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion12 pg
    Covers this model
  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MHW3000BG1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (26)

CodeMeaning
dLDoor lock error (saved as F5E2)dUDoor unlock error (saved as F5E3)F#E#Generic system error code (any F#E# code other than those specifically listed).F1E1ACU errorF1E2Motor control errorF2E3Unsupported cycleF3E1Water level system errorF3E2Temperature system errorF4E0Heater is not detectedF5E1Door switch errorF5E2Door will not lockF5E4Door not opened between cyclesF6E2Communication error UI to ACUF6E3Communication error ACU to UIF7E1Motor drive errorF7E2Motor drive circuit over temperatureF7E8Motor over temperatureF8E0Steam inlet valve error (not available on all models)F8E1No water detected entering washer or water level sensor trip not detectedF8E3Overflow conditionF9E1Long drainLo FLNo water detected entering washer or water level sensor trip not detected…ntInterruptedrLLoad detected during the washer cleaning cycle (remove load)SdSuds detected (alternate display)SudSuds detected

Service modes (5)

  • Fault/Error Code DisplayFrom Service Diagnostic mode, press and release the 3rd button used to activate Service Diagnostic…
  • Quick Diagnostic TestFrom Service Diagnostic mode, press and release the 2nd button used to activate Service Diagnostic…
  • Service Diagnostic Mode1. Washer must be in standby mode (plugged in, all indicators off). 2. Wait 30 seconds after…
  • Software Version DisplayFrom Service Diagnostic mode, press and hold the 2nd button used to activate Service Diagnostic…
  • User Interface TestFrom Service Diagnostic mode, press and release the 1st button used to activate Service Diagnostic…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass