Maytag Washer Error Code F#E#

F#E# is a generic fault code format on Maytag washers that covers any error the control board detects which does not correspond to a specifically defined, named fault code. It indicates that the washer sensed an abnormal condition in one of its monitored systems. The exact nature of the fault is not identified by this general code, which is why a reset and retest is the first recommended step. If the code persists, a technician can use diagnostic mode to narrow down the source.

If the code clears after a reset and the washer completes a full cycle without returning the error, continued use is generally reasonable. However, if the code returns repeatedly or the washer stops mid-cycle, you should stop using it until the fault is identified. Running the machine with an unresolved fault could risk damage to clothing, the machine itself, or in rare cases involve water leakage.

Yes. If the code returns after performing the POWER/CANCEL reset procedure, the fault is persistent and requires hands-on diagnosis. A technician can access the washer's diagnostic mode to read more specific fault data and inspect the wiring, sensors, and control board to identify the actual failing component. Continuing to reset without addressing the root cause will not fix the underlying problem.

Press POWER/CANCEL once to clear the code, then press POWER/CANCEL again to restart the washer. If the fault was caused by a transient event like a power flicker or a temporary sensor glitch, the reset will likely resolve it and the code will not return. If the underlying problem is a hardware or wiring issue, the code will come back, and further diagnosis is needed.

The repair cost depends entirely on the root cause, which cannot be determined from the generic code alone. A service call and diagnostic visit typically runs in the range of $75 to $150 before any parts are factored in. If the issue turns out to be a wiring connection or a single sensor, parts and labor might total $100 to $250. A main control board replacement is more expensive, often ranging from $200 to $450 or more depending on the model.