mypros+
Model reference

Maytag QCAE2735

Washer

2 documents23 error codes10 service modes

Available documentation

Tech Sheet

  • MAT20MNA Technical Sheet40 pg
    Covers this model

Service Flash

  • Top-Load Washer Front Panel Pad1 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag QCAE2735.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (23)

CodeMeaning
F0E0No fault detected.F0E2Over suds condition detected; suds prevent basket from spinning up to speed or…F0E4High water temperature (105°F/41°C or higher) detected during rinse cycle.F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control fault on the motor control section of the main control.F2E1Stuck keyF2E3Mismatch of main control and UI; User Interface identification does not match…F3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPM.F8E1Long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F8E6No fillF9E1Long drain

Service modes (10)

  • Calibration Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the 'Rinse' LED is…
  • Clean Washer Cycle["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'In Use', 'Soak/Wash'…
  • Drain & Spin Cycle["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'Rinse' and 'Done' LEDs…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the 'Done' LED is…
  • Manual Overview Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'Final Spin' and 'Done'…
  • Quick Overview Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the 'Final Spin' LED…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","Place cycle selector…
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'Rinse', 'Final Spin'…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'Soak/Wash' and 'Done'…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until 'Rinse' and 'Final Spin'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass