Model reference
Miele G45X0
Dishwasher
2 documents33 error codes5 service modes
Available documentation
Tech Sheet
- TECHNICAL INFORMATION G 5xxx Futura Dishwashers159 pg
Service Manual
- G 5xxx Futura Dishwashers Technical Information157 pg
MyPros+ Max
Diagnose your Miele G45X0.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (33)
CodeMeaning
F00No fault registered.F01Water/heating NTC temperature sensor R30 or its connection leads are…F02Water/heating NTC temperature sensor R30 or its connection leads are…F11Drainage fault; water is present in the appliance and is not being drained off.F12Water intake fault at start of step; fewer than 15 pulses from flow meter B3/4…F13Water intake fault at end of step; the desired number of flow meter pulses has…F14Water intake faultF15Water intake faultF18Flow meter stationary state monitor fault; unexpected pulses detected from flow…F19Flow meter B3/4 stiff and not turning freely; satisfactory test routines to…F24Heater relay contact fault; 120VAC detected at ST5 on electronic board when…F25Target temperature fault; desired temperature not reached within the given time…F26Boiling protection; temperature at NTC temperature sensor has exceeded 194°F…F32Door lock does not close; the given time for retraction of the automatic door…F33Door lock does not open; the given time for extension of the automatic door…F36Door lock switch defective; switches S4 and S80 are closed at the same time.F40Electronic fault; a hardware fault that cannot be repaired by the service…F42Line frequency registration fault; cannot clearly establish whether line…F47Faulty interface between selection-display electronic (BAE) and control-power…F51Heater pressure switch fault; after heater relay K1/1 is activated, the…F52Heater pressure switch has reset during heating; program continues without…F63Slide shutter fault; no signal change at position switch even though slide…F67Circulation pump speed too low; checked 10 seconds after circulation pump startF68Circulation pump operating after shutoff; the frequency converter registers a…F69Circulation pump blocked; heater pressure switch contacts check fails while…F70Float switch fault; overflow float switch B8/3 has activated due to water in…F78Circulation pump fault; interrupted connection or faulty circulation pump…F79Circulation pump interaction fault; faulty communication between the frequency…F84Slide shutter positioning fault; position switch, drive motor, or slide shutter…F85Slide shutter signal change fault; a signal change was detected at the position…Service modes (5)
- Component Test (within Service Mode)After selecting Service Mode (Section 080-4.2), access the component test program
- Demo ModeAccess the service programming mode (Section 080-4.1) then select Showroom program
- Programming ModeSee the separate programming-mode guide (referenced in Section 080-4.1).
- Service ModeRefer to the separate service mode guide (removed from this document as of 5/16/2014).
- Service Mode (Component Test)See the separate service mode guide (referenced in Section 080-4.2)
Full entry steps, exit procedures, and test sequences are available in Max.
Related Miele dishwasher models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass