Model reference
Samsung DV393ETPAWRAC
Dryer
1 document10 error codes7 service modes
Available documentation
Service Manual
- CLOTHES DRYER Service Manual49 pg
MyPros+ Max
Diagnose your Samsung DV393ETPAWRAC.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (10)
CodeMeaning
2EElectronic control problem (over voltage error).AEElectronic control problem (communication error).AE3DR Ready Modem Wire Test failure (problem detected during wire test).bE2Invalid state of key circuit short for 30 seconds.dERunning the dryer with the door open.dFInvalid door state for more than 256 milliseconds.EtInvalid state of EEPROM communication.FEInvalid power source frequency.HEInvalid heating temperature detected while running the dryer.tEThe thermistor resistance is very low or high.Service modes (7)
- Continuous Run ModePress Mixed Load Bell + Dry Level (DV431/DV405) or Wrinkle Prevent + Time (DV231) for 7 seconds…
- Cycle Count ModePress the Mixed Load Bell (DV431/DV405) or Time (DV393) key in Service Mode.
- Data Display ModeWith Power On, press Adjust Up Key + Adjust Down Key for 7 seconds until it sends out a beeping…
- DR Ready Modem Wire TestAfter entering Service Mode, press the Wrinkle Prevent button to start the Wire Test
- Service ModeWith power on, press Mixed Load Bell + Temp keys for 7 seconds in normal mode until it sends out a…
- Software Revision ModeAt Service Mode, press Temp until it sends out a beeping sound.
- Touch Sensor Data Display ModeWith Power On, press Mixed Load Bell + Temp (DV431/DV405) or Wrinkle Prevent + Temp (DV393) for 7…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung dryer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax