Model reference

Sub-Zero I700TCI-RH

Name: Sub-Zero I700TCI-RH
Brand: Sub-Zero

Refrigerator

6 documents32 error codes19 service modes

Available documentation

Service Manual

Sub-Zero 700-2: Serials 1670316 to 2347395 — Service Manual165 pg
Covers this model
Sub-Zero Original: Prior to Serial 1670316 — Service Manual49 pg
Covers this model
Sub-Zero 700-3 Tall (3758412): After Serial 2377228 — Service Manual130 pg
Covers this model

Parts Manual

Sub-Zero 700-2: Serials 1670316 to 2347395 — Parts Manual40 pg
Covers this model
Sub-Zero Original: Serials 0 to 1670315 — Parts Manual30 pg
Covers this model
Sub-Zero 700-3 Tall: After Serial 2377228 — Parts Manual44 pg
Covers this model

MyPros+ Max

Diagnose your Sub-Zero I700TCI-RH.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Sub-Zero Refrigerator

-- on my Sub-Zero I700TCI-RH

M+

Unit is in shutdown mode; all unit

From Service Manual 701492, p.24:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (32)

CodeMeaning

--Unit is in shutdown mode; all unit functions suspended except lights and door…-20Zone thermistor is unplugged or faulty (open circuit) in the indicated zone.-88Red wire of display cable is unhooked or faulty; top lights off and keys…05Refrigerator cabinet thermistor read open or shorted for 10+ seconds, or…06Refrigerator evaporator thermistor read open or shorted for 10+ seconds, or…07Freezer cabinet thermistor read open or shorted for 10+ seconds, or repeatedly…08Freezer evaporator thermistor read open or shorted for 10+ seconds, or…20Defrost under-heat with no voltage feedback through Gray/White wire at defrost…21Defrost overheat.22No voltage feedback through Gray/White wire at defrost start.23Defrost overheat with no voltage feedback through Gray/White wire at defrost…24Defrost under-heat.30Excessive icemaker water valve solenoid activation (exceeded 15 seconds).40Excessive freezer compressor run.50Excessive refrigerator compressor run.55Zone thermistor is shorted in the indicated zone.80High variable speed compressor differential pressure or low voltage supplied to…81High amperage draw at variable speed compressor (700TF/I-2V only).82VS compressor could not maintain lowest minimum speed at highest current draw…83Locked variable speed compressor rotor (700TF/I-2V only).84Short circuit at VS compressor controller output circuit (700TF/I-2V only).85VS compressor converter overheated and shut down VS compressor (700TF/I-2V…86Serial communication failure between VS compressor controller and electronic…87Speed information from electronic control board is out of specification…88Electronic control board not receiving status data in response to speed…E0Communication error between control board and control panel (base units only).E3Communication error between control board and control panel (base units only).ECExcessive compressor run with error codes registered in the electronic control…EECompartment or evaporator thermistor (or its wiring) is open, shorted, or has a…ICEFlashing ICE and SERVICE annunciators indicate water valve solenoid was…

View all 32 error codes

SERVICEFlashing SERVICE annunciator alone indicates excessive compressor run time or…SuBlue wire of display cable is unhooked or faulty; top lights off.

Service modes (19)

Diagnostic ModeWith unit ON, press and hold either COLDER key, then press the UNIT ON/OFF key, then release both…
Diagnostic Mode (Base Units)1
Diagnostic Mode (Tall Units)1
Manual Compartment Disable Mode (Tall Units only)1
Manual Component Activation ModeWith unit ON, press and hold the desired zone COLDER key and the UNIT ON/OFF key for 10 seconds
Manual Component Activation Mode (Tall Units only)1
Manual Defrost Initiation["Turn OFF master power switch for 10 seconds.","Turn master power switch back ON.","Control will…
Manual Freezer Evaporator DefrostPress and hold the ICE ON/OFF key for 5 seconds, then release.
Manual Zone Disable ModeSwitch unit OFF using UNIT ON/OFF key
Sabbath ModeSwitch unit OFF using UNIT ON/OFF key
Set Mode (Temperature Adjustment)["Press ZONE key to activate set mode and display setpoint for each zone.","Press ZONE key until…
Showroom ModeSwitch unit OFF using UNIT ON/OFF key
Shutdown Mode["Attempt to set temperatures warmer than control limits."]
Temperature Log Recall Mode - Compartment and Evaporator (Tall Units)1
Temperature Log Recall Mode - Compartment Only (Tall Units)1
Temperature Log Recall Mode (Compartment and Evaporator)With unit ON, enter Diagnostic Mode first
Temperature Log Recall Mode (Compartment Only)With unit ON, press and hold the desired compartment WARMER key, then press the UNIT ON/OFF key…
Temperature Units Selection ModeMust be performed within the first minute after switching the unit ON
Temperature Units Selection Mode (Fahrenheit/Celsius)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Sub-Zero refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass