Model reference

Whirlpool W10057361A

Dryer

1 document25 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet - W10057361A16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10057361A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

AF on my Whirlpool W10057361A

M+

Low inlet air flow detected at

From Tech Sheet W16939489, p.21:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFLow inlet air flow detected at installation.F:01Primary control failure.F:02Stuck button or user interface mismatch F:20No voltage detected at the heater relay F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open F:25Inlet thermistor is shorted F:26Motor drive system failure.F:28Moisture sensor strip is open F:29Moisture sensor strip has shorted F:30Restricted air flow condition exists F:31Low voltage condition (less than 30V) has been detected F:50No voltage detected at the water valve relay F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).L2Low line voltage (less than 30V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (3)

Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)["In Standby mode (dryer plugged in but not powered up), press and hold the Dryness Level button…
Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…
Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass