Model reference

Whirlpool W10156036A

Dryer

1 document21 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet W10156036 110 C6808270016 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10156036A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

AF on my Whirlpool W10156036A

M+

Restricted air flow condition exists.

From Tech Sheet W18539748, p.40:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (21)

CodeMeaning

AFRestricted air flow condition exists.F-01Primary control failure.F-02Stuck button or user interface mismatch (only appears in diagnostic test mode).F-22Exhaust thermistor is open.F-23Exhaust thermistor has shorted.F-24Inlet thermistor is open (only appears in diagnostic test mode).F-25Inlet thermistor is shorted (only appears in diagnostic test mode).F-26Motor drive system failure.F-28Moisture sensor strip is open (only appears in diagnostic test mode).F-29Moisture sensor strip has shorted (only appears in diagnostic test mode).F-30Restricted air flow condition (only appears in diagnostic test mode).F-40Communication between the machine control and motor control is lost.F-41Blower motor failure.F-42Motor control detects a voltage less than 90 VAC (undervoltage failure).F-43Motor control detects a low voltage condition (undervoltage warning); dryer…F-44Motor control electronics failure.F-45Motor control electronics speed sensor failure.F-46Motor control detects an over-current or over-torque condition.F-50No voltage detected at the water valve relay (only appears in diagnostic test…L2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.

Service modes (3)

customer_focused_drying_mode_adjustment["Press and hold the Dryness Level button for 5 seconds.","Dryer beeps and displays CF for one…
diagnostic["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes Dry…
manual_load_test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass