Model reference

Whirlpool W10156734A

Dryer

2 documents21 error codes5 service modes

Available documentation

Tech Sheet

For Service Technician Only - do not Remove or Destroy16 pg
Covers this model
Tech Sheet W10156734A MGDB800VQ016 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10156734A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

F:01 on my Whirlpool W10156734A

M+

Primary control failure in the machine

From Tech Sheet W18331273, p.45:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (21)

CodeMeaning

F:01Primary control failure in the machine control electronics.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:20Heater failure F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted air flow condition exists (only appears in diagnostic test mode).F:31L2 line voltage error F:50Water valve failure F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).PFPower failure occurred while the dryer was running.

Service modes (5)

Customer-Focused Drying Mode Adjustment1
Diagnostic Test Mode1
Factory Default Reset1
Line Voltage Display DiagnosticAfter entering the Diagnostic Test Mode, wait for the 5 second delay and cycle through any saved…
Manual Load Test1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass