Model reference

Whirlpool RBS277PVS03

Oven

6 documents22 error codes6 service modes

Available documentation

Tech Sheet

Tech Sheet - W10343435 - Rev A16 pg
Covers this model

Service Flash

Service Pointer - PF Error Code and/or Slow Running Clock5 pg
Covers this model

Tech Tip

Instruction Sheet1 pg
Covers this model

Installation Guide

Installation Instructions16 pg
Covers this model
Installation Instructions8 pg
Covers this model
Instruction Sheet1 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool RBS277PVS03.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Oven

F0 on my Whirlpool RBS277PVS03

M+

No error(s) found - default status

From Tech Sheet W18210045, p.17:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (22)

CodeMeaning

F0No error(s) found F1Electronic control malfunction (applies to all E codes under F1).F2 E0Key held down too long, or key is shorted.F2 E1Keypad keytail not connected.F2 E5Cancel key drive line open.F2 E6Cancel key drive line open.F2-E0Key held down too long, or key is shorted.F2-E1Keypad keytail not connected.F2-E5Cancel key drive line open.F2-E6Cancel key drive line open.F3 E0Temperature sensor opened (R=2875 ohms by spec).F3 E1Temperature sensor shorted (R=825 ohms by spec).F3 E2Oven temperature too high, over 575°F (302°C) in Cook mode.F3 E3Oven temperature too high, over 950°F (510°C) in Clean mode.F3-E0Temperature sensor opened (R=2875Ω by spec).F3-E1Temperature sensor shorted (R=825Ω by spec).F3-E2Oven temperature too high, over 575°F (302°C) in Cook mode.F3-E3Oven temperature too high, over 950°F (510°C) in Clean mode.F5 E0Door is opened but latch is locked; door switch is open indicating open door…F5 E1Self-Clean latch will not lock/unlock.F5-E0Door is opened but latch is locked F5-E1Self-Clean latch will not lock/unlock.

Service modes (6)

Bake Temperature Offset AdjustmentPress and hold BAKE for 5 seconds
Cavity Size Programming (Self-Clean Models)Within 60 seconds of power up, press the following keypads in sequence
Cavity Size Programming (Standard-Clean Models)Within 60 seconds of power up, press the following keypads in sequence
Error Code RetrievalPress and hold CANCEL key for 5 seconds.
Fahrenheit/Celsius TogglePress and hold BROIL for 5 seconds to toggle temperature between Fahrenheit and Celsius settings.
Fault Code DisplayPress and hold CANCEL key for 5 seconds.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass