Model reference
Whirlpool RBS305PDS16
Oven
10 documents36 error codes11 service modes
Available documentation
Tech Sheet
- Whirlpool Oven RBS305PDQ6 Tech Sheet4 pg
- TECH SHEET - Whirlpool Range RBS305PDT1612 pg
- TECH SHEET - Whirlpool Oven YRBS305PDQ912 pg
Service Manual
- Dimension Guide1 pg
- Kitchenaid Whirlpool Built In Single Double Electric Wall Ovens D Models Service Manual146 pg
- Service Manual 4317164 bochniak146 pg
Installation Guide
- Installation Instructions10 pg
- Instruction Sheet1 pg
Other
- Rev A_830175812 pg
- servicemanual 4317164.pdf146 pg
MyPros+ Max
Diagnose your Whirlpool RBS305PDS16.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (36)
CodeMeaning
F0Default F codeF1Default F-CodeF1 E0Communications failure or EEPROM checksum failure.F1 E2UL A/D Error(s).F1-E0Key held down too long, or key is shorted.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6Electronic control malfunction (associated with CANCEL key drive line).F2Keypad is not connected, keypad held too long, or keypad is shorted.F2 E0Shorted key detected.F2 E1Key tail error (membrane tail connection issue).F2-E0Temperature sensor opened (R=2875 ohms by spec).F2-E1Temperature sensor shorted (R=825 ohms by spec).F2-E2Oven temp too highF2-E3Oven temp too highF3Wiring harness cavity size does not match the previously stored value (cavity…F3 E0Oven temperature sensor unplugged or open circuit.F3 E1Oven temperature sensor shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F3-E0Door is open but latch is locked (door switch open indicating open door and…F3-E1Self-clean latch will not lock or will not unlock.F3-E2Oven temp too highF3-E3Oven temp too highF4Temperature sensor open.F5Temperature sensor shorted or oven temperature is too high (runaway)F5 E0Door and door switches do not agree (door position mismatch).F5 E1Door latch not operating.F5 E2Latch error during clean cycle.F5-E0Door is open but latch is locked (condition exists when door switch is open…View all 36 error codes
F5-E1Self-clean latch will not lock or will not unlock.F6Shorted meat probe or miswired temp probe.F7Oven door latch will not lock.F8Oven door is open but latch is locked.F9Oven door latch will not unlock, or common wire (+5Vdc) to latch switch and…PFPower failure indication (not a failure of control).
Service modes (11)
- Bake Temperature Offset AdjustmentPress BAKE key for 5 seconds
- Fahrenheit to Celsius ConversionPress the BROIL key for 5 seconds
- Fahrenheit to Celsius display changePress the BROIL keypad for 5 seconds
- Oven temperature calibrationTouch and hold the BAKE keypad for 5 seconds. The display will indicate the present oven…
- Programming the Cavity Size (Self-Clean models)Within 60 seconds of power up, press the following keys
- Programming the Cavity Size (Standard-Clean models)Within 60 seconds of power up, press the following keys
- Retrieve last error codePress and hold CANCEL/OFF key for 5 seconds
- Sabbath mode - Double oven1
- Sabbath mode - Single oven1
- Temperature adjustment (calibration)Press and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
- Verify Cavity Size ProgrammingPress and hold CANCEL key for 5 seconds, then press and hold START key for 5 seconds.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass