mypros+
Model reference

Whirlpool RBS305PDT13

Oven

6 documents35 error codes11 service modes

Available documentation

Tech Sheet

  • Whirlpool Oven RBS305PDQ6 Tech Sheet4 pg
    Covers this model
  • TECH SHEET - 4451884 - Rev A6 pg
    Covers this model

Service Manual

  • Kitchenaid Whirlpool Built In Single Double Electric Wall Ovens D Models Service Manual146 pg
    Covers this model
  • Service Manual 4317164 bochniak146 pg
    Covers this model

Installation Guide

  • Instruction Sheet1 pg
    Covers this model

Other

  • servicemanual 4317164.pdf146 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool RBS305PDT13.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
F0Default F codeF1Default F-CodeF1 E0Communications failure or EEPROM checksum failure.F1 E2UL A/D Error(s).F1-E0Key held down too long, or key is shorted.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6Electronic control malfunction.F2Keypad is not connected, keypad held too long, or keypad is shorted.F2 E0Shorted key detected.F2 E1Key tail error (membrane tail connection issue).F3Wiring harness cavity size does not match the previously stored value (cavity…F3 E0Oven temperature sensor unplugged or open circuit.F3 E1Oven temperature sensor shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F3-E0Temperature sensor opened.F3-E1Temperature sensor shorted.F3-E2Oven temperature too highF3-E3Oven temperature too highF4Temperature sensor open.F5Temperature sensor shorted or oven temperature is too high (runaway)F5 E0Door and door switches do not agree (door position mismatch).F5 E1Door latch not operating.F5 E2Latch error during clean cycle.F5-E0Door is open but latch is locked (door switch indicates open door and latch…F5-E1Self-clean latch will not lock.F5-E5Self-clean temperature 550°F (288°C) not reached within 45 minutes.F5-E7Self-clean latch will not unlock.F6Shorted meat probe or miswired temp probe.
View all 35 error codes
F6-E0Switch pulse return line not connectedF7Oven door latch will not lock.F8Oven door is open but latch is locked.F9Oven door latch will not unlock, or common wire (+5Vdc) to latch switch and…PFPower failure indication (not a failure of control).

Service modes (11)

  • Bake Temperature Offset AdjustmentPress BAKE pad for 5 seconds
  • Fahrenheit to Celsius ConversionPress the BROIL pad for 5 seconds
  • Fahrenheit to Celsius display changePress the BROIL keypad for 5 seconds
  • Oven temperature calibrationTouch and hold the BAKE keypad for 5 seconds. The display will indicate the present oven…
  • Programming Cavity Size (Self-Clean models)Within 60 seconds of power up, press the following touchpads in order
  • Programming Cavity Size (Standard-Clean models)Within 60 seconds of power up, press the following touchpads in order
  • Retrieve last error codePress and hold CANCEL/OFF key for 5 seconds
  • Sabbath mode - Double oven1
  • Sabbath mode - Single oven1
  • Temperature adjustment (calibration)Press and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
  • Verify Cavity Size ProgrammingPress and hold CANCEL pad for 5 seconds, then press and hold START pad for 5 seconds. The first…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass