Model reference

Whirlpool GR563LXSB2

Range

1 document11 error codes3 service modes

Available documentation

Tech Sheet

Whirlpool Range GR563LXSS1 Tech Sheet6 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GR563LXSB2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F1-E0 on my Whirlpool GR563LXSB2

M+

EEPROM communications failure, possibly

From Tech Sheet W13620643, p.15:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (11)

CodeMeaning

F1-E0EEPROM communications failure, possibly caused by power line noise or lightning.F1-E1EEPROM checksum failure, possibly caused by power line noise or lightning.F2-E0Key contact closed for more than 60 seconds due to key held down too long…F2-E1No communication between keyboard and control due to keytail being loose…F3-E0Break (open) in oven sensor circuit due to open sensor, loosened or…F3-E1Short in oven sensor circuit due to shorted sensor, sensor shorted to casing…F3-E2BAKE/BROIL temperature out of range (too high)F3-E3Clean temperature out of range (too high)F5-E0Door switch open during clean cycle due to switch failing open, open or loose…F5-E1Latch switch not operating GoodNo failure detected; displays only when user enters diagnostic mode and there…

Service modes (3)

Manual Diagnostics Mode 1Enter within 120 seconds of power-up
Manual Diagnostics Mode 2Enter after 120 seconds of power-up
Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass