Model reference

Whirlpool W10600809

Range

1 document18 error codes9 service modes

Available documentation

Tech Sheet

Fiche technique - Tech Sheet - W10600809 - Rev A (FR)24 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10600809.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F1E0 on my Whirlpool W10600809

M+

EEPROM communication error (internal

From Tech Sheet W18679628, p.40:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (18)

CodeMeaning

F1E0EEPROM communication error (internal control fault).F1E1Upper RTD sensor not calibrated (internal control fault).F1E2Lower RTD sensor not calibrated (internal control fault).F1E5Sensor usage out of range (internal control fault).F1E7PCB sensor/thermistor open or short-circuited.F1E9WIDE queue full.F2E0Keypad disconnected from oven control module.F2E1Stuck key detected on keypad.F2E2Stuck key detected on keypad.F3E0Upper (main) oven temperature sensor open or short-circuited.F3E1Lower (main) oven temperature sensor open or short-circuited.F5E0Door switch and door position switch mismatch during clean mode.F5E1Door latch does not operate properly during clean mode.F6E0Loss of communications between control modules.F6E1Bake mode runaway temperature (oven temperature exceeded safe limit during…F6E2Clean mode runaway temperature (oven temperature exceeded safe limit during…F6E3Warming drawer runaway temperature (exceeded safe limit).F9E0Product is miswired (incorrect wiring detected).

Service modes (9)

Control Reset (Soft Reset)1
Diagnostic ModePress CANCEL > CANCEL > START
Display Test1
Faults (View/Clear Error Codes)1
Semi-Automatic Test1. Enter diagnostic mode (CANCEL > CANCEL > START). 2. Press TEMP/TIME '+' or '-' (or keys 3 or 6…
Temperature Calibration1
Test Mode (Manual Relay Activation)1
Usage Mode1
Version1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass