Model reference

Whirlpool WEG745H0LZ5

Range

4 documents24 error codes3 service modes

Available documentation

Service Manual

Dimension Guide3 pg
Covers this model

Tech Sheet

Tech Sheet - W11565458 - Rev A2 pg
Covers this model

Service Flash

Installation Pointer - W11729886 - Rev A - Powercord Requirements6 pg
Covers this model

Quick Reference

Slide-In Gas Range Control Guide20 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WEG745H0LZ5.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

C-81 on my Whirlpool WEG745H0LZ5

M+

Over temperature condition on induction

From Tech Sheet W13153267, p.39:

1.Access service mode to confirm the active fault code and read stored error history.

2.Disconnect the sensor and measure resistance. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens. A reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part WP8577274

Temperature thermistor

Error codes (24)

CodeMeaning

C-81Over temperature condition on induction cooktop.C-82Over temperature condition on induction cooktop.C-83Temperature sensor stuck on induction cooktop.F-12Coil under current on induction cooktop.F-21Supply power frequency error on induction cooktop.F-25Stuck fan on Induction Power System (IPS) (Right or left side fan, depending on…F-36Temperature sensor is not working on induction cooktop.F-37Temperature sensor is not working on induction cooktop.F-40Induction Power System (IPS) failure.F-42Power supply error on induction cooktop.F-43Under voltage condition on induction cooktop.F-47Power supply from Induction Power Control (IPC) to User Interface is missing…F-56Wrong or invalid configuration on induction cooktop.F-58Wrong or invalid configuration (IPS) on induction cooktop.F-60User Interface does not work on induction cooktop.F1E0EEPROM Communication Error on oven control.F2E0Keypad Disconnected from oven control.F2E1Stuck Keypad on oven control.F3E0Main Oven Sensor Open or Shorted.F3E2Drawer Sensor Open or Shorted.F6E1Oven Temperature excessive.F8E0Cooling Fan Speed Too Low.F8E2Cooling Fan Speed Too High.F9E0Miswired

Service modes (3)

Clear Error CodesEnter Diagnostic Mode by pressing CANCEL>CANCEL>START within 5 seconds
Diagnostic ModePress CANCEL > CANCEL > START within 5 seconds.
Diagnostic Sub-menusAfter entering Diagnostic Mode, press the number 3 or 6 keypads to scroll through sub-menus

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass