Model reference
Whirlpool YSF379LEKQ1
Range
5 documents12 error codes2 service modes
Available documentation
Tech Sheet
- Tech Sheet - 82731898 pg
Service Flash
- Technical Service Pointer - Gas Freestanding Ranges with Direct Spark Ignition (DSI) Control18 pg
Installation Guide
- Installation Instructions32 pg
- Instruction Sheet2 pg
Other
- Service Pointer - W10622771 (Burner May Not Ignite)_W1062277118 pg
MyPros+ Max
Diagnose your Whirlpool YSF379LEKQ1.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (12)
CodeMeaning
F1 E0EEPROM communications failure.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F2 E0Shorted key on control panel.F2 E1Key tail unplugged from control.F3 E0Oven temperature sensor circuit is open.F3 E1Oven temperature sensor circuit is shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F5 E0Door switch and latch switch do not agree.F5 E1Latch motor not operating or latch switch failure.F5 E2Door latch error during Clean cycle.Service modes (2)
- Last error code recallPress and hold CANCEL/OFF key for 5 seconds
- Temperature calibration adjustmentPress and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass