mypros+
Model reference

Whirlpool W11348497

Washer

1 document21 error codes8 service modes

Available documentation

Tech Sheet

  • Technical Service Sheet W1134849744 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W11348497.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Service modes (8)

  • Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Spin LED is ON (all…
  • Calibration Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Rinse LED is ON…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Done LED is ON (all…
  • Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Spin and Done LEDs…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off). Wait 10 seconds after…
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Rinse, Spin, and…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Wash and Done LEDs…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn the cycle selector knob until the Rinse and Spin LEDs…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass