mypros+
Model reference

Whirlpool W11415436

Washer

1 document21 error codes8 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W11415436 - Rev A56 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W11415436.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F0E0No fault detected.F0E2Oversuds condition detected; suds prevent basket from spinning up to speed or…F0E4High water temperature detected (105°F / 40°C or higher) during rinse cycle.F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control fault on the main control board.F2E1Stuck key; one or more keys on the User Interface were actuated for 16…F2E3Switch mismatch; switches do not match the console or are not operating…F3E1Pressure system fault; main control detects an out of range pressure signal.F5E1Lid switch fault; lid is in locked state but lid switch is open, control not…F5E2Lid lock fault; lid lock has not moved into locked position or motor cannot be…F5E3Lid unlock fault; lid lock has not moved into unlocked position or motor cannot…F5E4Lid not opened between cycles; user presses Start after several consecutive…F7E1Basket speed fault; main control cannot determine speed of basket or speed…F7E5Shifter fault; main control cannot determine position of shifter.F7E6Motor fault; indicates an open clockwise or counterclockwise circuit of the…F7E7Motor unable to reach target RPM; basket speed sensor detects that target RPM…F8E1No fill or long fill; water level does not change for a period of time or water…F8E3Overflow condition; main control senses water level that exceeds the washer's…F8E5Hot and cold inlet hoses are reversed.F9E1Long drain; water level does not change after drain pump is on for 10 minutes.

Service modes (8)

  • Automatic Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Drain/Spin'…
  • Calibration Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Rinse' LED is…
  • Fault Code Display Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Done' LED is…
  • Manual Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until 'Drain/Spin' and 'Done'…
  • Service Diagnostic Test Modes (entry)["Ensure washer is in standby mode (plugged in with all indicators off). Wait 10 seconds after…
  • Software Version Display Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until 'Rinse', 'Drain/Spin'…
  • Tachometer Verification Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until 'Wash' and 'Done' LEDs…
  • UI Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until 'Rinse' and 'Drain/Spin'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass