Model reference

Whirlpool W11427032

Washer

1 document34 error codes1 service mode

Available documentation

Tech Sheet

Service Technician Technical Sheet W11427032A2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W11427032.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

F0E2 on my Whirlpool W11427032

M+

Oversuds condition detected during wash

From Tech Sheet W15214987, p.39:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (34)

CodeMeaning

F0E2Oversuds condition detected during wash cycle.F0E3Overload condition detected.F0E4Spin limited by water temperature.F0E5Off balance load detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ring condition detected.F0E9Off balance pause during cycle.F1E1Main Control (ACU) fault.F1E2Motor drive module over voltage condition.F2E1UI stuck button detected.F2E2UI disconnected from control.F3E2Pressure system fault.F3E3Inlet water temperature fault.F3E5Mini Bulk dispensing system error.F5E1Lid switch fault F5E3Lid will not lock or unlock.F5E4Lid not opened between cycles.F6E1Communication error F6E3Communication error F7E1Tachometer missing or wrong signal.F7E2MCI drive failure.F7E3Basket engaged during wash.F7E4Basket re-engagement failure.F7E6Motor circuit open.F7E7Motor unable to reach target RPM.F7E8Motor drive module over temperature.F7E9Locked rotor condition detected.F7EAMotor phase lost.F7ECMotor drive module over current/overload.F8E1Long fill

View all 34 error codes

F8E2Dispenser system failure.F8E3Overflow or flood condition detected.F8E6Water hazard condition detected.F9E1Long drain fault

Service modes (1)

Service Mode1. Ensure washer is in standby mode (plugged in with all indicators off). 2. Select any three (3)…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass