ASKO Washer Error Code Draining fault

The draining fault on Asko W640, W650, and W660 washers means the drain pump ran for 180 seconds during an emptying cycle without successfully draining the tub, causing the control board to stop and reset the program to zero. It indicates a restriction or failure somewhere in the drainage path. Common sources include a clogged pump filter, a kinked hose, or a blocked drain outlet.

The washer automatically resets the program counter to zero when the draining fault occurs, but this does not resolve the underlying blockage. Simply power cycling the machine may allow you to start a new cycle, but the fault will return if the drainage obstruction has not been physically cleared. Always address the root cause before attempting another wash cycle.

If the fault is caused by a kinked hose or a clogged filter, the repair costs nothing beyond your time. If a service technician is needed for diagnosis, expect labor costs in the range of $80 to $150 depending on your location. A failed drain pump motor requiring replacement can add $100 to $250 or more in parts costs on top of labor.

Start by checking the drain hose for kinks and confirming the outlet is not obstructed at the standpipe or utility sink connection. Next, locate and clean the drain pump filter, removing any lint, coins, or foreign objects. After clearing any blockages, run Program 10 (Emptying) to confirm the machine drains successfully before resuming normal use.

The machine stops the cycle automatically when this fault triggers, so the immediate risk of overflow is low. However, standing water left in the drum for an extended period can promote mold and odor growth. You should address the blockage and drain the tub as soon as reasonably possible, using Program 10 once the cause is cleared.