ASKO Washer Error Code E2

E2 means the drain pump ran for 180 seconds during the drain cycle without successfully emptying the washer, so the machine stopped and reset the program. This is a protective function to prevent pump damage. The most common cause is a blocked needle trap or a restricted drain hose. Clearing the obstruction is usually all that is needed to resolve the error.

You should not continue running the washer while E2 is active, as the machine has already stopped and reset the program as a safety measure. Running additional cycles before resolving the drainage issue risks leaving standing water in the drum and can put unnecessary strain on the pump motor. Address the drain restriction first before attempting to run another wash cycle.

If the fix is simply cleaning the needle trap or clearing a kinked hose, there may be little to no cost beyond your time. If the drain pump motor has failed and needs replacement, repair costs including parts and labor typically range from $150 to $350 depending on your location and service provider. Getting a diagnostic visit from a qualified technician will give you a more accurate estimate for your specific situation.

Start by locating and cleaning the integrated needle trap in the drain pump, as debris buildup there is the most frequent cause. Next, inspect the drain hose for kinks or blockages and confirm the household standpipe is draining freely. Once the obstruction is cleared, restart the washer to see if it drains normally. If the error persists after addressing blockages, the drain pump itself may need to be tested or replaced.

Resetting the washer may temporarily clear the E2 display, but the error will return if the underlying drain restriction is not fixed. The code appears because the pump could not drain the water in time, so until the blockage or pump issue is resolved, the washer will trigger E2 again during the next drain cycle. Always correct the root cause before relying on a reset.