ASKO Washer Error Code E

The E error code on an Asko washer indicates a drain pump error. It appears when the drain pump has run continuously for 180 seconds without successfully emptying the drum. At that point, the washer stops the program and resets. The error points to a restriction or failure somewhere in the drain system.

Resetting the washer may clear the display temporarily, but the error will return if the underlying drain problem has not been fixed. The washer resets itself automatically as part of the error sequence, so the issue must be resolved before the machine will complete a full cycle. Address the drain blockage or pump fault first, then restart the program.

If the fix is simply cleaning the needle trap or clearing a hose blockage, there is no parts cost involved, though a service call fee typically ranges from around 75 to 150 dollars. If the drain pump motor needs replacement, parts and labor combined can range from approximately 150 to 350 dollars depending on the specific model and your location. Getting a diagnostic visit first helps confirm whether a simple cleaning or a full pump replacement is needed.

Start by locating and cleaning the integrated needle trap at the drain pump, as a clogged trap is the most frequent cause of this error. Also inspect the drain hose for kinks or blockages, and confirm the household standpipe drains freely. If the filter and hose are clear but the error returns, the drain pump motor may need to be tested or replaced.

You should not continue running the washer until the drain issue is resolved. When the E error appears, the washer has already halted and reset the program to prevent potential overflow or pump damage. Running repeated cycles without addressing the fault can stress the pump motor further and may result in standing water remaining in the drum.