ASKO Washer Error Code E6

E6 means the washer's PCB (control board) has logged an internal error event. The code itself does not describe a specific component failure but rather signals that a fault was recorded and stored in the board's memory. A technician must access the PCB Manual Test Mode, following steps 3 through 6, to retrieve the specific details of what triggered the log entry.

It is generally not recommended to continue running the washer while an undiagnosed error is logged in the PCB. Because the specific nature of the fault is unknown until the log is retrieved, operating the machine could potentially worsen an underlying problem. Have the error log read before resuming normal use.

Repair costs depend entirely on what the PCB error log reveals as the underlying fault. A diagnostic service call to retrieve and interpret the log typically runs in the range of $75 to $150. If a component such as the PCB itself needs replacement, total repair costs including parts and labor could range from $200 to $500 or more depending on the specific part required.

Retrieving the error log requires running the PCB Manual Test Mode, which involves a specific sequence of steps that may be beyond a typical DIY repair. If you are comfortable with appliance diagnostics and following technical procedures precisely, you may be able to access the log. However, interpreting the results and performing any follow-up repairs will likely require a qualified technician.

A simple power reset may clear the active display of E6, but the error event will remain stored in the PCB log until it is properly addressed. Clearing the display without reading and resolving the underlying fault means the root cause remains undiagnosed and the error will likely return. The log should be retrieved and the fault corrected before assuming the issue is resolved.