ASKO Washer Error Code E8

The E8 code on an Asko washer is an Initial Operation Fail Error. It means the control board detected an abnormal or missing signal from the Hall IC sensor when the motor attempted to start. The Hall IC monitors motor rotation, and if it cannot confirm the motor is spinning correctly, the washer shuts the motor down and displays E8. The fault is related to the motor connection, the Hall IC sensor, or the wiring between these components.

Start by powering the washer off and on to reset the error, then attempt to run a cycle again. If E8 returns, inspect the wiring harness connectors at the motor and Hall IC sensor to ensure they are fully seated and free of corrosion. If the connections look secure, the Hall IC sensor or the motor itself may need to be tested and potentially replaced. A technician with a multimeter can check motor resistance and sensor output to pinpoint the exact fault.

Repair costs vary depending on the failed component. If the issue is simply a loose or corroded connector, the repair may only involve a service call fee, typically in the range of $75 to $150. Replacing a Hall IC sensor generally adds $50 to $150 in parts. A full motor replacement is the most expensive scenario, with parts and labor potentially ranging from $250 to $500 or more depending on your location and the specific model.

Turning the washer off and back on will clear the E8 error display and allow the machine to attempt a fresh start. However, if the underlying cause, such as a loose connector or a faulty Hall IC, has not been resolved, the error will return as soon as the motor tries to operate again. A power cycle is a useful first step to confirm whether the fault is intermittent or persistent.

No, you should not continue running the washer while the E8 error is active. The control board stops the motor specifically to prevent further damage when it detects an abnormal sensor signal. Running a load without a functioning motor signal could worsen an existing wiring or motor issue and may leave laundry stuck in the drum mid-cycle.