ASKO Washer Error Code IE

IE stands for Input Error on an Asko washer, indicating a water supply problem. The machine was unable to reach the required water level within 5 minutes during a fill or re-fill phase of the wash cycle. The most common causes are a closed water tap or a blocked filter screen on the inlet hose. Resolving the water supply restriction will allow the cycle to proceed normally.

The washer will halt the cycle automatically when the IE code is triggered, so it will not continue operating without adequate water. It is safe to leave the machine in this paused state while you diagnose the water supply issue. Do not attempt to force the cycle forward without first resolving the fill problem, as running certain components dry can cause damage over time.

If the fix is simply cleaning the inlet hose filter screen or opening the water tap, there is no parts cost involved. Replacing a water inlet valve typically costs between $40 and $120 for the part, plus labor if a technician is hired. A pressure switch replacement generally runs in the $25 to $80 range for the component. Total repair costs including professional labor can range from $100 to $250 or more depending on the specific fault.

Start by confirming the water supply tap behind the machine is fully open. Next, disconnect the inlet hose from the back of the washer and clean the small mesh filter screen at the connection point, as sediment buildup is a frequent cause of restricted flow. Also check the hose itself for kinks or crushing. If those steps do not resolve the issue, the water inlet valve or pressure switch may need to be inspected or replaced.

A reset may clear the code temporarily, but the error will return at the next fill cycle if the underlying water supply issue has not been corrected. To clear the code permanently, you must address the root cause, such as opening the water tap, cleaning the hose filter, or repairing the inlet valve. Resetting without fixing the problem is not a lasting solution.