ASKO Washer Error Code LE

LE stands for Lock Error on an Asko washer. It indicates a door opening fault, meaning the machine attempted to start a cycle while the door was open, or the door lock switch failed to confirm that the door was properly secured. The washer will not operate until this condition is resolved. Start by firmly closing the door and retrying the cycle.

No, you should not attempt to force the washer to run while the LE error is active. The error exists precisely to prevent the machine from operating with an unsecured door, which could result in water leaking from an unlatched door during the cycle. Address the underlying cause before resuming normal use.

If the fix involves only reseating a loose connector or adjusting the door, there may be no parts cost at all. Replacing a faulty door lock switch typically runs in the range of $30 to $90 for the part, plus labor if a technician is performing the repair. A worn latch or strike assembly can add additional parts cost, and total repair bills including labor generally range from $80 to $200 depending on parts needed and local service rates.

Begin by making sure the door is pushed completely shut until you hear or feel it click into the latch. If the error remains, inspect the door lock switch connector and terminal connections for looseness, corrosion, or damage and reseat any loose connectors. If those checks pass, the door lock switch or the latch assembly itself may need to be tested and replaced. A qualified technician can perform resistance testing on the switch to confirm whether it has failed.

A reset may temporarily clear the LE code, but the error will return if the underlying problem is not corrected. If the door was simply not fully closed, resetting after properly latching the door may resolve it permanently. If the fault is due to a defective door lock switch, loose connector, or worn latch, those components must be repaired or replaced before the code will stay clear.