ASKO Washer Error Code Motor fault

The motor fault error on Asko washers (W640, W650, W660) indicates that the control system has detected either a broken or open-circuit condition in the motor wiring, or an internal failure within the drive motor itself. When the fault is detected, the washing program is immediately stopped to protect the machine. The drum will not rotate again until the underlying issue is diagnosed and corrected.

No. The washer intentionally interrupts the program when this fault is detected because continuing to operate with a motor wiring fault or failed motor could cause further electrical damage or overheating. Do not attempt to force the machine to run until the fault has been properly diagnosed and repaired.

Repair costs vary depending on the root cause. Wiring repairs or connector replacements are typically the least expensive, often in the range of $50 to $150 for a service call and labor. A drive motor replacement on an Asko washer can range from $200 to $500 or more, depending on parts availability and labor rates in your area. A control board replacement may fall in a similar or higher range.

Some causes of this error, such as a loose connector or a visibly damaged wire, can be addressed by a knowledgeable DIYer comfortable working with appliance wiring. However, testing motor windings for continuity and replacing the motor or control board requires basic electrical tools and familiarity with disassembling the washer cabinet and drum assembly. If you are not confident working with electrical components, it is safer to contact a qualified technician.

A power reset may temporarily clear the error display, but if the underlying wiring or motor problem has not been fixed, the fault code will return as soon as the machine attempts to run the motor again. Resetting without repairing the root cause is not a reliable solution and can delay proper diagnosis.