ASKO Washer Error Code Temperature stop

Temperature stop means your Asko washer failed to heat the wash water to the selected temperature within the allowed time limit. The limit is 25 minutes for wool wash cycles and 80 minutes for all other cycles. When this timeout expires without the target temperature being confirmed by the sensor, the machine stops and displays this fault. The issue is most commonly traced to the heating element or the temperature sensor.

You should not continue running cycles while the Temperature stop error is present. The machine has halted the cycle because a heating fault was detected, and continuing to attempt washes without diagnosing the root cause could result in inadequate cleaning, repeated faults, or in the case of a partially failed element, a potential electrical hazard. Address the fault before resuming normal use.

Repair costs vary depending on which component has failed. Replacing a heating element or NTC thermistor typically involves parts costs in the range of $30 to $150 depending on the specific model, plus labor if a technician is hired. Control board replacement is considerably more expensive, often ranging from $150 to $400 or more for parts alone. Getting a diagnostic assessment from a technician first is the best way to avoid unnecessary parts replacement.

Some basic checks are within reach of a confident DIYer, such as verifying water inlet pressure, checking for error recurrence after a reset, and inspecting accessible wiring connections for obvious damage. However, testing and replacing the heating element or NTC thermistor requires disassembling the machine and working near mains voltage components, which carries serious risk if you are not experienced with appliance repair. A qualified technician is recommended for any work involving the heating circuit.

A reset may clear the displayed error temporarily, but the fault will return on any cycle that requires heating if the underlying problem is not repaired. If the heating element, thermistor, or wiring are faulty, the same timeout condition will occur again and trigger the error. Resetting is useful only as a diagnostic step to confirm the error is repeatable, not as a solution.