Bosch Dishwasher Error Code E:2060

E:2060 means the dishwasher's control board has detected that one or more NTC temperature sensor resistance values are outside the permitted range. As a result, the dishwasher disables the heater and continues operating without it. The fault points to the NTC sensors themselves, the wiring connecting them, or their connectors. Diagnosis requires inspecting the wiring and measuring the sensors with a multimeter.

A reset may temporarily clear the code, but if the underlying fault with the NTC sensor or wiring is still present, the error will return during the next cycle. Resetting without repairing the root cause will not restore normal heating operation. A proper repair requires testing and correcting the wiring or replacing the faulty sensor.

If the fix is simply reseating a connector or repairing a damaged wire, out-of-pocket costs can be minimal. Replacing an NTC temperature sensor is generally an inexpensive part, with the sensor itself typically ranging from around $15 to $50 depending on the specific model. If a professional technician is needed, a service call plus labor can add $100 to $250 or more to the total. Control board replacement, if required, is the most costly scenario and can range from $200 to $400 or higher.

Start by checking all wires and connectors in the NTC sensor circuit for damage, corrosion, or loose connections, since wiring faults are a common cause. If the wiring is intact, measure the resistance of the NTC sensors directly with a multimeter to determine whether they are reading correctly for the ambient temperature. A sensor showing an open or shorted reading will need to be replaced. If both the wiring and sensors test correctly, the control board may require further evaluation.

The dishwasher is designed to disable the heater when E:2060 is active, which prevents overheating from an uncontrolled heating element. Running the machine in this state is not immediately dangerous, but wash and dry results will be significantly below normal since the water will not reach the correct temperature. It is best to diagnose and repair the fault promptly rather than continue extended use with the heater disabled.