Crosley Range Error Code F3

F3 on a Crosley range means the electronic control system has detected a fault or anomaly. Any code beginning with F indicates an electronic irregularity identified by the control board's built-in diagnostics. It may be caused by a power fluctuation, a failing control board, or a wiring issue. If the code clears after pressing CLEAR/OFF it may have been a temporary glitch, but a recurring F3 requires a technician.

It is not recommended to continue using the range while an active F3 fault code is displayed. The code indicates the control system has detected an electronic problem, which means the oven may not operate as intended. Press CLEAR/OFF to silence the alert and stop operation, then avoid using the appliance until the fault has been resolved or confirmed to be a one-time event.

A reset by pressing CLEAR/OFF will clear the displayed F3 code and stop the audible signal immediately. If the fault was caused by a temporary power fluctuation or minor electronic glitch, the code may not return after reprogramming. However, if an underlying hardware problem exists, the F3 code will recur and a reset alone will not resolve the issue permanently.

You can attempt the recommended first step yourself: press CLEAR/OFF to clear the code and the audible alert, then reprogram the oven. If the error does not return, no further action may be needed. If F3 reappears after reprogramming, the issue involves a hardware component such as the control board or wiring, and contacting an authorized service technician is advised.

Repair costs depend on which component is at fault. A service call and diagnosis typically runs between $75 and $150. If a control board replacement is needed, parts and labor combined can range from $150 to $400 or more depending on the specific board and local labor rates. Wiring repairs or connector fixes are generally on the lower end of the cost range.