Crosley Range Error Code F15

The F15 code means the oven's electronic control board has detected a fault or error condition. It is a general alert generated by the control board when it identifies something operating outside normal parameters. The code triggers during bake or broil operation and causes the oven to stop and beep. It may result from a power fluctuation, a corrupted board state, or a component failure within the control system.

You should not attempt to continue using the oven while the F15 code is actively displayed, as the control board has detected an abnormal condition and stopped operation for a reason. You can attempt the recommended reset procedure to see if normal operation resumes. If the code keeps returning, avoid using the bake or broil functions and contact a qualified technician before further use.

If the F15 code returns after both the initial clear and the 5-minute power reset procedure, the fault is likely due to a hardware failure within the control board or associated wiring. At that point, the recommended step is to record the fault code and contact a qualified appliance service technician. Continuing to reset without addressing the underlying cause will not resolve a persistent hardware problem.

Resetting the range can clear the F15 error if it was caused by a temporary glitch or power fluctuation. Press Clear/Off to stop the beeping, then try operating the oven again. If the code returns, disconnect power to the appliance for at least 5 minutes before repowering and setting the clock. If the fault recurs after this full reset sequence, the issue is likely a hardware failure requiring service.

If the issue is a simple power fluctuation, there is no repair cost beyond your time spent resetting the appliance. If the control board needs to be replaced, repair costs typically range from $150 to $400 or more depending on parts and labor rates in your area. Getting a diagnostic quote from a technician before committing to the repair is a good idea.