Crosley Range Error Codes

11 error codes for Crosley range models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

FThe oven control system has detected a fault or anomaly F__Electronic control has detected a fault condition (any F code error, e.g., F11).F10Oven control has detected a fault or error condition.F11Electronic control system has detected a fault (example code referenced in…F13Oven control has detected a fault or error condition.F14Oven control has detected a fault or error condition.F15Oven control has detected a fault or error condition.F3Electronic control system has detected a fault (example code cited in…F30The oven control system has detected a fault or anomaly (example code shown in…F31Oven control has detected a fault or error condition.F90Oven control has detected a fault or error condition.

MyPros+ Max

Get the full diagnostic procedure for any Crosley range error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Crosley Range

F on my Crosley Range

M+

The oven control system has detected a fault or

From Service Manual 302440, p.12:

1.Press CLEAR/OFF to clear the displayed code and stop the audible signal. Try using BAKE or BROIL functions again. If the F error code reappears, disconnect power for 5 minutes, reconnect, reset the clock, and try BAKE or BROIL again. If the problem persists, note the error code and call a service technician.

2.Measure door lock assembly resistance across the PTC terminals. Expected: ~200 ohms cold, rising sharply once energized.

3.Inspect strike and latch alignment. A warped door or misaligned strike prevents the switch stack from closing in the correct sequence.

Part 5304517277

Door lock assembly

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started