Electrolux Cooktop Error Code 15

Error code 15 indicates that the right rear (RR) zone control circuit or the On/Off key sensor on the right side Touch Control Board is defective or not communicating correctly. The cooktop's control system has detected a fault in that sensor or its associated wiring. This may prevent the right rear zone or the entire cooktop from operating normally.

It is not advisable to continue using the cooktop while this fault code is active. A defective On/Off key sensor means the cooktop may not respond reliably to power commands, which creates an unpredictable operating condition. Discontinue use until the fault is diagnosed and repaired.

Resetting the cooktop by cutting power at the breaker for a few minutes may temporarily clear the display, but the fault code will return if the underlying issue with the RR zone control or On/Off key sensor has not been resolved. A reset is not a fix and should only be used as part of the diagnostic process, not as a long-term solution.

A knowledgeable DIYer can start by inspecting the cables and connectors leading to the right side Touch Control Board, checking for loose connections, bent pins, or visible damage. If the wiring checks out and the fault persists, the right side Touch Control Board will need to be replaced. Working inside a cooktop involves electrical components, so the appliance should be fully disconnected from power before any inspection or repair.

If only a wiring connection needs reseating, the repair cost may be limited to a service call fee, typically in the range of $75 to $150. If the right side Touch Control Board requires replacement, parts and labor combined generally fall in the range of $150 to $400 depending on the specific model and local labor rates.