Electrolux Cooktop Error Code E015

E015 indicates a failure in the ESEC self-test, where ESEC refers to the Electronic Surface Element Control system that manages the cooktop's heating zones. During startup, the ESEC module runs a diagnostic check and has detected a problem it cannot pass. The cooktop disables operation until the fault is resolved. The first area to check is the wiring harness connecting the ESEC module to the User Interface Board.

No, you should not attempt to use the cooktop while E015 is active. The error indicates that the Electronic Surface Element Control system has failed its diagnostic check, meaning the cooktop cannot guarantee safe and proper operation of the heating elements. Keep the unit powered off until the fault has been diagnosed and repaired.

Repair costs vary depending on the failed component. If only the harness connector needs reseating or the harness itself needs replacement, costs are generally low, typically in the range of $20 to $80 for parts. Replacing the ESEC module or the UIB involves higher parts costs, often ranging from $100 to $300 or more per board, plus any applicable labor charges from a qualified technician.

If the cause is a loose or unseated harness connector between the ESEC module and the UIB, a knowledgeable DIYer comfortable working inside appliances may be able to reseat the connector and clear the fault. However, if the harness, ESEC module, or UIB itself has failed, replacing those components typically requires some technical experience with appliance electronics. Always disconnect power to the cooktop before inspecting any internal wiring.

A power reset, such as turning off the circuit breaker for 30 seconds and restoring power, may temporarily clear the code if the fault was caused by a transient issue or a briefly unseated connector. However, if an underlying hardware problem exists with the harness, ESEC module, or UIB, the E015 error will return. A reset alone is not a repair and the root cause should still be investigated.