Electrolux Cooktop Error Code E030

E030 indicates that the AC input voltage coming into the left-side induction housing assembly is too high. The cooktop requires 240VAC within a plus or minus 10% tolerance, meaning voltage must stay between approximately 216VAC and 264VAC. When voltage exceeds that upper limit, the unit shuts down and displays E030 to prevent damage to its internal components. The problem often originates in the home's electrical supply rather than in the cooktop itself.

No, you should not attempt to continue using the cooktop while E030 is active. The error indicates the unit is being exposed to voltage levels outside its safe operating range, which can damage inverter components and internal wiring. The cooktop's safety system has disabled operation for this reason. Have the voltage condition resolved before resuming use.

Repair costs depend on the root cause. If the issue is a utility supply problem, your power company may resolve it at no charge, though an electrician's diagnostic visit can range from $75 to $200 or more. If the home's branch circuit wiring needs correction, electrician labor and materials can range from $150 to $500 depending on the scope of work. If the Filter Circuit Board requires replacement, expect to pay for both the part and technician labor, which combined can range from $200 to $600 or higher depending on your location and the specific part pricing.

The first step is measuring the voltage at the Filter Circuit Board terminals X1/X2 and X4/X5 to determine whether the problem is the incoming power supply or the cooktop's components. Working inside the cooktop or at the electrical panel involves high-voltage circuits and should only be done by a qualified appliance technician or licensed electrician. If the issue is a utility supply problem, you will need to contact your power company. Replacing the Filter Circuit Board, if that is the diagnosis, requires a technician with induction cooktop service experience.

Resetting the cooktop by cycling the power may temporarily clear the fault display, but the E030 error will return if the underlying overvoltage condition has not been corrected. Because the fault is triggered by a live electrical condition, not a one-time event, a reset alone is not a fix. The incoming voltage must be measured and brought within the 216VAC to 264VAC acceptable range before the error will stay cleared.