Electrolux Cooktop Error Code E055

E055 indicates a break or open circuit in the temperature sensor for the right front induction zone. The cooktop detected that the sensor is no longer returning a valid signal, so it shut down that cooking zone as a safety measure. The fault can be caused by a loose connector, damaged wiring, or a failed sensor.

The right front induction zone will be disabled while E055 is active, so it cannot be used for cooking. The remaining zones may still function normally. Operating the cooktop with a disabled zone is generally safe, but the underlying fault should be diagnosed and repaired promptly to restore full functionality.

If the fix is simply reseating a loose connector, there may be no parts cost, though a service call fee can range from roughly 75 to 150 dollars. A replacement temperature sensor typically costs between 20 and 60 dollars in parts. If the control board requires replacement, parts alone can range from 150 to 350 dollars or more, with total repair costs varying based on labor rates in your area.

A homeowner or experienced DIYer can start by checking whether the sensor connector at the induction housing assembly is fully seated, which requires accessing the interior of the cooktop. If reconnecting the connector does not clear the fault, further diagnosis such as testing sensor resistance with a multimeter and inspecting the harness is possible for those comfortable with appliance repair. Replacing the sensor or control board is more involved and may warrant a qualified technician.

Powering the cooktop off at the breaker for a few minutes may temporarily clear the error display, but if the underlying sensor circuit break still exists, the code will return as soon as the unit attempts to use or monitor the right front zone. A reset alone is not a repair. The sensor connection, wiring, and sensor itself must be inspected and corrected.