Electrolux Cooktop Error Code E061

E061 indicates that the temperature sensor for the left front induction zone has detected an overtemperature condition. The cooktop triggers this fault to protect the inductor coil and surrounding electronics from heat damage. It is most frequently related to blocked ventilation or a cooling fan that is not functioning correctly. Resolving the airflow issue and allowing the unit to cool down will often clear the error.

No, you should stop using the left front burner zone until the cause of E061 is identified and resolved. The error exists to protect the cooktop from heat damage, and continuing to operate it while the fault is active could damage the induction coil, power electronics, or glass surface. Allow the unit to cool completely before any further troubleshooting.

If the fix is simply clearing a blocked vent or correcting installation clearances, there may be no parts cost at all. Cooling fan replacement typically runs in the range of $80 to $200 including parts and labor, depending on the specific model and service rates in your area. A temperature sensor replacement is generally less expensive, often in the $50 to $150 range, while control board issues at the higher end of diagnosis can bring total repair costs to $200 or more.

Some causes of E061 are DIY-friendly, such as clearing blocked vents, removing debris from around the cooktop, and verifying the unit has adequate installation clearances. If the error returns after the cooktop has cooled and ventilation is confirmed to be unobstructed, a failing cooling fan, defective temperature sensor, or wiring fault is likely involved, and those repairs typically require disassembly and component replacement. A qualified technician is recommended for internal component diagnosis and repair.

A reset by powering the cooktop off at the circuit breaker for several minutes may temporarily clear E061 after the unit has cooled down, but it will return if the underlying cause is not addressed. If the error reappears after a reset and a normal cooking session, the cooling fan, sensor, or wiring should be inspected rather than relying on repeated resets.