Electrolux Cooktop Error Code E076

E076 indicates a communication error between the ESEC-UIB control board and the Induction Housing Assembly for the right side cooking zones. The cooktop has lost the data link it needs to safely operate the right-side induction burners. The fault most often traces back to the communication harness running between the ESEC-UIB P9 connector and the Filter Circuit Board at connectors X20 or X14. Until the communication path is restored, the right-side zones will not function normally.

The right-side cooking zones affected by E076 should not be used while this fault is active. The cooktop has flagged a loss of communication to prevent uncontrolled or unsafe operation of those burners. Left-side zones may still function depending on the model, but it is best to have the fault diagnosed and repaired before relying on the appliance for regular cooking.

Repair costs vary depending on which component is at fault. If only the harness needs reseating or a short pigtail replacement, costs could range from around $75 to $150 for a service call alone. Replacing the Filter Circuit Board or the ESEC-UIB typically brings the total into the $200 to $500 range or higher, depending on parts availability and labor rates in your area. Getting a diagnosis before authorizing parts replacement helps avoid unnecessary expense.

A knowledgeable DIYer can start by disconnecting power, accessing the cooktop interior, and checking that the harness connectors at ESEC-UIB P9 and Filter Circuit Board X20 and X14 are firmly seated and free of visible damage. Reseating loose connectors sometimes resolves the fault without any parts replacement. However, if the harness, filter board, or ESEC-UIB needs replacement, those repairs require working inside a high-voltage appliance and are best handled by a qualified technician.

Cycling power to the cooktop by disconnecting it at the breaker for a few minutes may temporarily clear the display, but E076 will return if the underlying communication fault is still present. A reset does not repair a loose connector, damaged harness, or failed board. Persistent or recurring E076 errors require a physical inspection of the wiring and components to resolve the root cause.