Electrolux Cooktop Error Code SF

SF stands for Sabbath mode power failure recovery. It appears on the element and timer screens when the cooktop experienced a power outage while Sabbath mode was active. All heating elements turn off automatically during the outage, and SF is displayed to notify you of that interruption. The cooktop remains in Sabbath mode and is ready to use once the elements are restarted.

Yes, the SF indicator does not indicate a safety hazard or a component failure. The cooktop is fully operational and remains in Sabbath mode. The elements simply need to be turned back on. If the cooktop does not respond to input after the SF code appears, that would warrant further investigation of the control board or surface element switches.

There is no repair cost associated with the SF indicator under normal circumstances, because it is a status notification and not a fault requiring parts or service. If the SF code is accompanied by an actual failure to heat or a non-responsive control panel, a technician visit could range from around 75 to 200 dollars or more depending on what component is found to be at fault.

No repair is needed for the SF indicator. Simply restart any heating elements you were using by following the standard Sabbath mode operating steps for your cooktop model. The SF notification will clear once you resume normal Sabbath mode use. If you are not in a Sabbath observance period, you can exit Sabbath mode through the control panel.

The SF indicator is cleared by restarting the elements within Sabbath mode, not by resetting the appliance. Performing a power reset, such as switching the breaker off and back on, would restart the cooktop but would again display SF if the unit was in Sabbath mode before the reset. Simply resuming use in Sabbath mode is the correct response.