Electrolux Dishwasher Error Code SA

SA is a status confirmation code, not a fault or error. It appears when the SANITIZE option was selected and the dishwasher successfully reached the required sanitize temperature at the end of the wash cycle. The code displays for approximately 10 seconds and then clears automatically. No action is required.

Yes, dishes are safe to use after SA appears. The code confirms that the dishwasher reached the elevated temperature required to sanitize dishware during the final rinse. SA indicates successful sanitization, not a contamination or system problem.

No repair cost applies to the SA code because it is not a malfunction. It is a normal completion message for the SANITIZE cycle. If SA never appears after selecting the SANITIZE option, that could indicate a heating element or thermistor issue, and repair costs in that case would typically range from $100 to $300 depending on the faulty component and labor involved.

No action is needed. The SA code is a positive confirmation that the sanitize cycle completed successfully. It clears on its own after about 10 seconds. If you find it appearing unexpectedly, check whether the SANITIZE option is being activated before each cycle.

The SA code clears on its own after approximately 10 seconds without any reset needed. Since it is a status message rather than a fault, it is not latched into the control board and does not require a manual reset to dismiss.