Electrolux Dryer Error Code 67

Error code 67 on an Electrolux dryer indicates a heater sensing circuit failure. The main control board is unable to properly read the signal from the heater sensing circuit. This fault points directly to a failure within the main control board itself. The dryer will not operate normally until the board is replaced.

Resetting the dryer by unplugging it or cycling the power will not permanently clear error code 67. Because the fault is caused by a circuit failure within the main control board, the error will return as soon as the dryer attempts to run a cycle again. A board replacement is required to resolve the issue.

The cost to fix error code 67 will depend primarily on the price of the replacement main control board and any labor charges if a technician performs the repair. Main control boards for Electrolux dryers typically range from $100 to $300 or more depending on the model. Professional labor to diagnose and install the part can add another $75 to $175 to the total cost.

A knowledgeable DIYer can attempt this repair by first checking the wiring harness and connectors at the main board for corrosion or damage. If the wiring is intact, the main control board will need to be replaced, which requires disconnecting electrical components and accessing the control panel. If you are not comfortable working with electrical components in appliances, a professional technician is recommended.

You should not continue using the dryer while error code 67 is active. The heater sensing circuit is part of the system that monitors heating element operation, and a failure in this circuit means the dryer cannot properly oversee heat levels. Running the dryer in this condition could pose an overheating risk.