Electrolux Dryer Error Code E98

E98 on an Electrolux dryer indicates an inconsistent inverter board protocol, meaning the user interface board, main control board, and inverter board are not communicating correctly. This can be caused by incompatible boards, a faulty inverter board, or an incorrect main board configuration. The dryer will not operate until the communication issue is resolved.

A power reset may temporarily clear the E98 code, but if the underlying cause is a faulty inverter board, incompatible boards, or an incorrect main board configuration, the error will return when the dryer attempts to operate again. A reset alone is not a repair and should only be used as part of the diagnostic process.

Repair costs for E98 vary depending on which component is at fault. An inverter board replacement typically costs between $150 and $350 including parts and labor, while a main control board replacement can range from $200 to $450. If the issue is simply a wiring connection or a configuration correction, the cost may be limited to a diagnostic service fee in the range of $75 to $150.

Some causes of E98 can be addressed without professional help, such as reseating wiring harness connectors or verifying board compatibility after a recent repair. However, if the inverter board or main control board needs to be replaced, this involves working with high-voltage components and is best handled by a qualified technician. Always disconnect power before inspecting any internal components.

No, you should not attempt to run the dryer while E98 is active. The error indicates a control system communication failure, and operating the dryer in this state could cause improper motor control or further damage to the electronic components. Keep the dryer unplugged until the fault is properly diagnosed and repaired.